Note that my ECUFlash can read which means the cable is ok.Īlso attached are my logger def, do not know if that will effect connection.Īny input will be highly appreciated!!! Thanks for viewing!Īpologies for the length of this message, hopefully there is some interesting information for you here. I tried both with engine on and switch on. My question is: Can I ignore the data out of place situation and just go ahead and flash the ECU using stock def? I am scared that it will 'brick' the carĪttached are my stock rom, the OFT rom and the stock def I use.Īs for Romraider logger, I was not able connect to ECU at all, it shows a message: 'Sending ECU init' and "Unable to send ECU init" and as a result I could not see any real time data. The left one is stock rom using stock def (which I got from Github), the right side one is the OFT rom I got from their website. I attached a snapshot showing a simple parameter which is idle ctrl. When I try to load OFT OTS Rom with the same calid I notice a lot of data in that rom was out of place, that is using the stock ECU Def. Hi I use ECUFlash to pull the stock rom and my calid is:ZA1JF40C
0 kommentar(er)
